Where to put transformer waste oil?

Where to put used transformer oil? This question is more urgent than ever. Environmental safety is becoming one of the highest priority issues. In these conditions, there is an increase in requirements for the quality of the environment, which is affected by the formation and placement of waste.

 

Waste generation is a significant problem for many enterprises and structural units. Among other wastes, waste oils of different types, motor, transmission, and industrial, are characterized by large volumes of education.

 

If mistreated, waste oil can become a dangerous enough tool for environmental contamination. All-knowing statistics show that in the world in the soil and reservoirs waste oil is discharged in a volume that is much higher than the volume of emergency discharges of oil arising from its extraction, processing or transportation. Let’s see, where to put the used oil?

 

In industry, oil oils are primarily needed for lubricating various mechanisms and performing the functions of hydraulic fluid working fluids. In the electric power industry, such a product has found wide application for solving the problems of isolating current-carrying parts of equipment, removing heat and extinguishing the arc in high-voltage switches.

 

First, let’s figure out what is meant by the term “waste oil”. It is proposed to use the definition proposed by the Environmental Protection Agency: “Used oil is any oil derived from crude oil or synthetic oil, used and as a result of such use contaminated with physical or chemical impurities.”

 

In most cases, the exploitation of transformer maintenance is accompanied by the influence of many negative factors on them, among which is the pollution by mechanical impurities, contact with air oxygen and high temperature. As a result, over time, petroleum products lose their original properties, are oxidized or completely decomposed. Such phenomena are unacceptable, since they lead to the failure of expensive equipment in which oil oils are used. In some cases, even an easy one in a few minutes can be critical and incur large financial losses. Therefore, the replacement of waste oil or its restoration to its original state is seen as one possible method of solving the problem.

 

When operating the process equipment, prerequisites for mixing mud, metal particles, water or chemicals with oil often arise in such a way that over time, the oil product can no longer be used for direct use. To continue normal operation, the oil must either be replaced by a new one or regenerated.

 

Add a Comment

Your email address will not be published. Required fields are marked *